Fleet-engineers INS-01015 Manuel d'utilisateur télécharger pdf (Page 1)

Each Standard Pivot Bar Set Includes

A) Two Pivot Bar offset mount castings

B) Two Set Screws

C) Two 3/4 x 4” Bolts

D) Two 3/4” Nuts

E) Two 3/4” Lock Washers

1. Assemble post or end mount to

Pivot Bar with appropriate class

8 hardware for your application

torqued to 245 ft. lbs for 5/8” bolts

or 425 ft. lbs for 3/4” bolts.

Installation Sheet #INS-01015

11/01 • Rev. B-12/06

3. Rotate Pivot Bar to the desired position for mounting the

fender then tighten the Pivot Bar to the frame mounting bolt

and torque to 425 ft. lbs. minimum.

BACK VIEW

FRONT VIEW

Installation Sheet #INS-01015

For Mounting Quarter and Tandem Fenders

NOTE: For some end mount applications,

it may be better to assemble loosely at

ﬁrst and then torque at ﬁnal assembly.

4. Thread jamming set screw into hole. Adjust it to contact truck

frame and tighten to 13-15 ft. lbs. (recommended) or until a

slight deﬂection of the Pivot Bar is seen).

Pivot Bar Offset Mount

Castings (2)

Sets available with or without mounts

Fenders not included

2. Select a hole in the frame for mounting. Position Pivot

Bar to hole and attach loosely with appropriate hardware

5. Tighten nut or bolt to appropriate torque (245 ft. lbs for 5/8”

bolts or 425 ft. lbs for 3/4” bolts) on end or post mount if left

loose (from step 1). Attach fender on post or end mount in

accordance to the manufacturers instructions.

Tighten Nut

Behind Mount

Set Screws (2)

3/4 x 4” Bolts (2)

3/4” Nuts (2)

3/4” Lock Washers (2)

NOTE: These instructions for installation are intended to be a gen-

eral guide to help the installer. Because of the large number of

possible mounting conﬁgurations, the installer is responsible

for the installation design. Any modiﬁcations to the product are

at the discretion, responsibility and risk of the installer.

PATENT

#6,471,228

BACK VIEW 1
FRONT VIEW 1

Résumé du contenu

Page 1 - FRONT VIEW

Each Standard Pivot Bar Set IncludesA) Two Pivot Bar offset mount castingsB) Two Set ScrewsC) Two 3/4 x 4” BoltsD) Two 3/4” Nuts E) Two 3/4” Lock W

Commentaires sur ces manuels

Pas de commentaire

Fleet-engineers INS-01015 Manuel d'utilisateur Page 1

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Matériel Fleet-engineers INS-01015. Fleet Engineers INS-01015 User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Fleet-engineers INS-01015 Manuel d'utilisateur Page 1

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Matériel Fleet-engineers INS-01015. Fleet Engineers INS-01015 User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel Fleet-engineers INS-01015